
Factory-built homes
Reading your home's data plate: heat, wind and roof loads in Arizona
Every HUD-code home has a data plate that shows which climate and weather zones it was built for. Here's how to read it.
What the data plate is
Every manufactured home has a data plate, usually inside a kitchen cabinet, a bedroom closet or near the electrical panel. HUD's sample data plate shows what it lists: the manufacturer, the design zones the home meets, and the heating equipment installed.
Insulation zone (Uo value)
HUD's code divides the country into three thermal zones. The home's whole envelope has a maximum allowed heat-transfer rate in each zone, and it gets stricter as the zone number goes up: 0.116 in Zone 1, 0.096 in Zone 2 and 0.079 in Zone 3 (Btu per hour, per square foot, per degree F). The code also requires insulation in the cavities of exterior walls, floors and ceilings.
Heating capacity
The data plate states the lowest outdoor temperature at which the installed heating equipment can keep the home at an average of 70°F. That matters if you're building in Flagstaff or the higher country around Prescott and Paulden, where winters are colder than in the Valley or Eloy. Ask us to show you this figure for the plan you're considering.
Roof load and wind zone
The data plate also shows the roof-load zone (North, Middle or South, with the design load in pounds per square foot) and the wind zone the home was built for. Your local permitting office sets what's required where your land is, so confirm those requirements for your parcel before you order a home.
Beating the summer heat
Factory-built or site-built, a few things make the biggest difference in an Arizona summer: the home's orientation on the lot, shade on west-facing windows, a properly sized cooling system, and ducts and seals in good shape. Ask about window and insulation options when you choose your plan.
The research behind the article
